During the construction process, the decorative panel should be protected from moisture, placed in a ventilated and dry place, protected from the sun, and must be leveled. If the sanding effect on the factory panel is not good, clean it with fine sandpaper before construction. The surface is dusty and dirty, and the factory panel has good sanding. Just use soft feathers to remove dust and dirt, and no heavy sand can be used. Before use, it is necessary to brush the qualified primer on the board surface to prevent dirt from being stained during use and affecting the visual effect. Be sure to choose a qualified adhesive, the moisture content must be qualified, so as not to affect the appearance of the panel surface. The wall surface of the decoration and decoration must be completely dry and well protected against moisture. The wood used must be dry before use to prevent the decorative board from being discolored by moisture. The curvature of the panel should be appropriate and should not be too large to avoid damage to the material such as panel breakage.
Use a nitro varnish to brush the surface of the veneer (required to be a qualified paint). After each brushing, wait 30-60 minutes for the paint to dry out, sand the veneer again, and then paint a second time. According to the previous process and so on, it usually takes three or more times to paint.
After the completion of the construction, it is necessary to continue to brush the primer twice (the method is the same as before, and the brush needs to be polished after each brushing), and then the ash filling construction is carried out on the pinholes left during the construction, and the method of replacing the nails with the super glue is also used. The effect will be better, but the cost is slightly higher than nailing.
After the hole is filled, continue the brush five times as in the previous method until the nail hole is not visible at all.
After the entire paint is finished, polish the finish with water for 2 times or more until the trace of the brush is not visible.
After all the processes are finished, use paper paper to protect it from direct sunlight. Do not use it in the air outlet, heating cover or wet place, causing unnecessary mold, discoloration and cracking.
Wrecker Truck,Wrecker Tow Truck,Wrecker Towing Truck,Rotator Wrecker Truck
CLW GROUP TRUCK , https://www.clwgrouptruck.net