Having chosen a satisfactory bathtub, we were happy to prepare a comfortable hot bath, but the installation was a problem. Before and after the installation and the installation process, there are many places that require our attention. For example, how much is the height of the installation? What is the installation method? What are the precautions for installation? Here we introduce you.
Bathtub installation height:
The installation height of the bathtub can be 355 to 518mm for ordinary bathtubs, 475 for sitting-in bathtubs (310mm), 470mm for jacuzzis, and 1500mm for bathtubs. Therefore, we should pay attention when choosing a bathtub. Buying a bathtub size that suits us is very important for our home life. Sizes, big or small, can have a very bad influence on our lives.
Bathtub placement form:
There are two types of bathtubs in general: free-standing and embedded. The free-standing type places the bathtub directly on the floor of the bathroom. This method is easy to construct, easy to overhaul, and is suitable for use when the floor has been renovated. Embedded is to embed or partially embed the bathtub into the countertop. The embedded bathtub is easier and more convenient for access by the infirm.
Bathtub installation method:
The installation method of the bathtub firstly selects the bathtub of suitable size according to the specifications of the bathroom. It is believed that everyone will notice that according to the size of the bathroom in their home, select the appropriate bathtub size, so in the early stage of installation, we must first compare the size of the bathtub and the space reserved for the bathroom.
The next step is to install a specific bathtub. At the time of installation, according to the actual size of the bathtub, a brick-and-mortar skirt is used, the outer part and the upper part of the skirt are tiled, and the bottom part is made of bricks and a cement-laid platform, and the height is preferably set to the bottom of the bathtub.
Then the bathtub is opened and the package is snapped in from the upper part, and the sewer pipe is connected so that the bottom of the bathtub skirt is in contact with the skirt. This must be careful, from the installation to the sewer pipeline must pay attention to the bath and the surrounding.
In the end, we recommend you to install the bathtub. In order to stabilize the bathtub and prolong the service life of the bathtub, it is recommended that the glass be glued on the place where the bathtub contacts the skirt and the wall. This will effectively keep the bottom of the bathtub dry and thus extend the use. life.
Bathtub installation notes:
1, before the installation to determine the various circuit diagrams, and check the outlet and inlet, to figure out the hot and cold water direction of the pipeline, when the installation will save a lot of things.
2. After the bathtub is installed, the bathtub can be filled with water to check if the bathtub is leaking. When there is no problem, open the drain and check the drainage condition.
3. Check whether the bathtub level, front and rear, right and left positions are appropriate, and check whether the drainage facilities are suitable. During the installation process, the bathtub and the water installation shall be protected against dirt, bumps and clogging. The sparks of the angle grinder and spot welder should not be splashed on the bathtub. Otherwise, the glaze will be damaged and the bathtub will be affected.
4, pay attention to bathtub protection. During bath installation and home renovation, the surface of the bathtub can be covered with a soft material, do not stand on the bathtub for construction, or place weight on the edge of the bathtub to prevent damage to the bathtub. Bathtub can be used only after 24h.
<\p><\div>
Ningbo DSS Intelligent Technology Co., Ltd , https://www.dssking.com