Newly purchased a MHW three-layer XCR Jackets, to play for a long time, compared to the many Jackets previously seen, self-inductance of a good donkey skin function design some experience, write for everyone to take a picture.
1, appearance (although the appearance and function is not really contact, but many donkeys still require "beautiful" first). It's very simple, spelling is better than monochrome, and brighter than dark.
2, fabrics. Of course it is rainproof and breathable. Check out the XCR and think it is 20% more breathable. The three-layer coating is the best, and it is lighter. Because it is difficult to make, it also shows the strength of the manufacturer. The outer layer is a grid-shaped tear-resistant nylon. Shoulder, elbow, forearm under the fight fabric should be significantly different and overall, thick, anti-wear. How to identify true and false, etc. is not wordy, and there are many related articles.
3, start from scratch. The overall head cap is inverted pear. The front of the head protrudes in a hat-like shape, and the texture is stiff. There are two adjustment points on the head. First, at the back of the head, one-handed tightening can reduce the lateral surface perimeter to ensure that the "small head" donkey does not feel "fluttering", and the reverse adjustment of one-handed pull can be done. Although this adjustment point is in the back of the brain, but the position is moderate, the adjustment knot is obvious and can be touched by raising one hand. The second is the elastic cord on the face (I wonder if it is called so). It is also a one-handed operation (the same below). The tightening rope is not close to the brim, but is used to make the brim a position to ensure that the brimmed hat does not deform when tightened. Will not be tightly wrapped in the scalp, affecting the effect of rain.
Headgear can be folded into the collar.
4, collar. Collars, head caps, and front plackets are linked styles. Under the collar, the zipper has a more lining (texture is harder, otherwise it will often be caught in the zipper), preventing the brewing when the zipper is not fully pulled dead. A layer of flannel is on the inside of the collar to give your chin a close-fitting look at low temperatures.
5, before the embarrassment. At the lower side of the front edge, it is folded back about 2 and 3 mm outwards. When it is windy or in motion, it is blocked by this small “dam†and rain does not penetrate the zipper. For the first time this design noticed, the feeling was considered very thoughtful.
6, waist, wind skirts, hem tight rope. These three kinds of designs are very common. There are one or two designs in the Jackets. There are not many such three-in-one designs. Windproof skirts not only have snaps, but also with Velcro, Velcro's rough surface can be reversed when not in use to stick to one side, to prevent sticking to other clothing.
7, breathable mouth. There are 4 vents, 2 underarms, and 1 in the front of the chest. In addition to the zipper, these two vents are also equipped with Velcro, and the Velcro can be folded and glued inwards to form a small bracket to open the upper and lower sides of the vent to enhance air circulation.
8, zipper. Of course YKK big teeth, anti-clip design. There is no inner zipper on the inside, but it's not a bad idea to think of the jacket and fleece separately.
9, sleeves. The elbow and upper arm of the sleeve are wide, and the contraction from the elbow to the wrist is large. In this way, when designed to wear more, it not only ensures windproofness, but also provides freedom from bending and movement. With the straight bucket design, the sleeves will be picked up when “bendingâ€, which is inconvenient.
Finally, I said one thing at the time. I was showing off at the time with awe to Ahfu. Ahfu groped his face in admiration and said: "Good things are good things. Look at people's designs. Even the small pockets inside are so exquisite... "what? What little pocket? How do I not know, the probe looked, suddenly five thunderstruck, cry no tears: What is that little inside pocket ah, is the front of the chest side of the pressure open! ! ! Ah Fu this guy is still struggling to look inside it ... so when you buy do not forget to check the pressure strip, is flat, whether the seam is in the middle of the pressure strip, with or without bubbles, folds, pressure strip edge There are no edges in the corner, but I don't like the one I like.
BNF HARDWARE CO., LTD , https://www.bnfhardware.cn