Carving a pumpkin is simpler than you think, but the shell of the pumpkin is very hard, and the part of the flesh is thick and thick, so you should make it strong when you engrave it. In fact, the tools for making pumpkin lights are very simple. They are commonly used in our daily life: a large spoon or an ice cream scoop, a thin, sharp knife and some old newspapers . It’s as simple as we can it has started!
Halloween pumpkin lamp carving
1. Cutting:
At the top/bottom of the pumpkin, cut the melon with a knife to reach out and smash the melon. The cut surface should be as flat as possible.
2. Hollowing
Use a special spoon or a daily spoon to carefully pour out the seeds and melons. Select the place where you are going to engrave and scrape the piece of skin to a thickness of 1 inch.
3. Paste paper Facebook
At the selected place, glue or nail the paper face prepared in advance. When using the pushpin, be careful to pin the dotted line on the face to avoid small holes on the melon.
4. Trace along the dotted line
Trace the face on the pumpkin skin with a small cone or pushpin along the dotted side of the paper's face. After finishing, tear off the paper Facebook.
5. Finally, correct the point with a small awl. It seems that it is not easy to make a beautiful pumpkin lamp! But be sure to try it!
Plastic Ruler,Glue Stick,Liquid Glue,Paint Brush Set
NINGBO MACEY EDUCATION PRODUCT CO.,LTD , https://www.maceytoys.com